Uploading text nodes: conversion file does not work | BPC 10.0

Hi gurus,

I am uploading master data and hierarchy from infoobject 0COSTCENTER to my BPC dimension ZCECO.

I've followed the "How To - Import Master Data and Hierarchies into SAP BusinessObjects BPC 7.5 from SAP NetWeaver BW".

I am in BPC 10.0 NW SP 21.

I am facing with a problem with the import of text nodes, which have an ID concatenated with the Controlling Area. I want to import them without Controlling Area. For example: in BW I have a text node "P0011ES401P" and I need to convert it in "1ES401P" for BPC dimension. The Controlling Area is "P001".

The cost center's ID does not have concatenated the Controlling Area. For example: In BW I have the ID "3401111001" and when I upload, I see in the dimension sheet "3401111001" as a member (without Controlling Area prefix)

I am using the package /CPMB/IMPORT_IOBJ_MASTER to upload master data and text nodes. When I run it, the text nodes are imported with the Controlling Area prefix. The conversion file does not work.

This is my transformation file:

This is my conversion file "CECO_CONVERSION.xls":

This conversion file should work. But not.

When I run el package /CPMB/IMPORT_IOBJ_MASTER, this is my set selection for 0COSTCENTER:

I've tried to import in several ways, with external/internal format and with update/overwrite option. I've tried all combinations and the result is the same. I don't manage to remove the Controlling Area prefix.

Due to I could not convert data with conversion file level, I also tried to make the conversion data at transformation file level. But my problem is that my text nodes do not have the same lenght in their ID's. For this reason, I can not put something like this in *MAPPING:

ID=*IF(ID(1:4)=*STR(P001) Then ID(5:14);ID)

I get an error of "command failed: end position is out of record index". I explored about this error and the solution was using the conversion file instead the transformation file, but neither.

I make sure that I put the correct transformation file into the prompt of the package and I have the correct name of my conversion file in *CONVERSION part of transformation file.

The fact is that I am able to import text nodes without Controlling Area prefix (as I want), but I have to run again the package and using another transformation file. But I want to get it in one step, as the How To explains.

I would appreciate any help,

Kind regards,

Manu